Crestron xpanel not allowing password to be set

#Crestron xpanel not allowing password to be set update

When a control system is received from the factory or restored to factory defaults, entering the control system hostname or IPВ address into a web browser with an ' prefix will redirect you to the '/setup' endpoint to allow for device configuration. OFFВ - Turns user page authentication off for the control system.ON - Turns user page authentication on for the control system.

OFFВ - Turns authentication off for the control system.ON - Turns authentication on for the control system.

TLS1.2ONLY - Sets TLS 1.2 support exclusively for client and server connections.

-P - Used to supply a password for opening the private key file when SSL is set to CA.

CA - Sets SSL to use CAВ (Certificate Authorities)В issued certificates.

SELFВ - Sets SSL to use self-signed certificates.

OFF - Turns SSL off for the control system.

The following table summarizes the different authentication permutations. The user will be prompted for credentials as they load the project initially instead of when the projectвЂ™s WebXPanel library tries to access the control system via the WebSocket.

For 4-Series control systems, it is recommended to set userpageauth to on to improve the experience for the end user.

For 3-Series control systems that have the setting available because FORCED_AUTH_MODE is true, userpageauth must be set to on.

#Crestron xpanel not allowing password to be set update

If the FORCED_AUTH_MODE setting is false, then you will need to update the SSLВ and authentication settings for the control system.ДЇor systems that have FORCED_AUTH_MODE set to true, the userpageauth command regulates whether web page resources require credentials to be accessed. NOTE:В Issue the ver -v command to view information about your control system. For older 3вЂ‘Series control systems, these settings may need to be updated. NOTE:В The syntax for each command is provided at the end of this section.ДЇor 4вЂ‘Series control systems and 3вЂ‘Series control that have been recently purchased or restored to factory defaults, the ssl and authentication commands will be properly configured to use the HTML5 Web XPanel feature. The three commands to control these settings are ssl, authentication, and optionally userpageauth. The control system must require authentication to access resources and must enable secure, encrypted communications. Authentication CommandsД¬restron has set high security standards for using the HTML5 Web XPanel feature on the control system. For more information, refer to Add or Remove HTML5 Web XPanel Support and Add XPanel to Custom (NonвЂ‘Template)В Project. You will need to change the WebXPanel library configuration if you change the WebSocket port from the default value. The securewebsocketport console command can change the default port number. A new service port is made available on the control system to support secure WebSocket communications that are supported in browsers and by the CH5 WebXPanel library. HTML5 Web XPanel is hosted in a web browser and, as a result, can not communicate to the control system via TLS sockets like other touch screens. For example, if the port was changed to 8443, the following example URL would change from '' to 'вЂ‘template/index.html'. You will need to append the port to the URL to reference the project on the control system if the port was changed from the default.

No parameter - Displays the current value.

portnumber - Sets the desired port number (in decimal notation).

The service port for HTTPS protocol can be changed from the web standard (443) to another port number using the securewebport command. HTML5 XPanel requires the use of HTTPS protocol on the control system. NOTE:В Ensure that the control system is running the minimum required firmware version or higher as described in Dependencies. Use the following console commands to configure the control system for an HTML5 Web XPanel project deployment.